Abstract

Ultra precision cutting should be satisfied with two conditions of Mirror Like and shape grade, and especially Mirror Like depends on surface roughness. In this study, in order to develop Mirror Cutting for Al alloy, this was done with edge form of single crystal diamond tool divided into R type and S type. Surface roughness machined by S type tool is more satisfactory than by R type tool, being the lowest value of 13.8nm. In addition, Mirror surface can reach above 90% of reflection rate by both R type and S type tool, but machined surface by R type tool has much more fine fracture portions rather than by S type tool. Even though feed rate decreases from 5.mu.m to 1.mu.m, surface roughness doesn't show improvement.

본 연구에서는 천연다이아몬드의 인선형상을 R형과 S형으로 구분하여 제작하 고 미세이송과 절삭속도 변화를 주어 이에 얻어지는 표현거칠기, 칩 생성기구 및 경면 성을 검토하였다.

Keywords

• Ultra Precision Cutting;
• Mirror Like Cutting;
• Surface Roughness;
• Edge Form of Single Crystal Diamond Tool;
• Chip Formation

• 초정밀가공;
• 경면가공;
• 표면거칠기;
• 단결정 다이아몬드공구의 인선형태;
• 침형태;