Filling Imbalance in 3 Plate Type Injection Molds with Multi-Cavity

다수 캐비티를 갖는 3매 구성 사출금형에서의 충전 불균형

  • 제덕근 (부경대학교 대학원 정밀기계공학과) ;
  • 정영득 (부경대학교 기계공학부)
  • Published : 2004.06.01

Abstract

Injection molding is the one of the most important processes for mass production of plastic parts. Usually injection molds for mass production are constituted to multi-cavity runner system to manufacture the more parts at a time. Multi-cavity molds are designed to geometrically balanced runner system to uniformly fill to each cavity. But, when injection molding is performed using a mold with balanced runner system filling imbalances are occurred between the cavity to cavity. The previous studies by Beaumont at. all reported that filling imbalance occurred by thermal unbalance on the mold and viscosity variation of resins and so on. In this study, we conducted experiments in order to know the causes of filling imbalance for 3 plate type mold with 8 cavities. And we exhibited a new so called 4BF mold (4 plate type Balanced Filling Mold) to be possible filling balance. We conducted a experimental injection molding to verify the efficiency of the 4BF mold. In the results of the experiment, we could confirmed the balanced filling possibility of the 4BF mold.

Keywords

References

  1. Beaumont, John. P., Young, Jack H., 'Mold Filling Imbalances in Geometrically Balanced Runner Systems,' Journal of Injection Molding Technology, Vol 1, No.3, 1997
  2. Jeong, Y. D., Park, T. W., Kim, H. P., 'The Easy Injection Mold for Plastic Processing,' Inter Vision, pp.224-227, 2003
  3. Beaumont, John P., Young, Jack H., Jawoski, Matthew J., 'Solving mold Filling Imbalance in Multi-Cavity Injection Molds,' Journal of Injection Molding Technology, Vol. 2, No. 2, pp.47-58, 1998
  4. Beaumont, John P., Ralston, J., Worth, A. S.,'Troubleshooting Cavity to Cavity Variations in Multi-Cavity Injection Mold,' Journal of Injection Molding Technology, Vol. 3, No. 2, pp.88-98, 1999
  5. Beaumont, John P., Boell, K., 'Controlled Balanced Molding through New Hot Runner Manifold Design,' ANTEC 2001, pp.932-936, 2001
  6. Beaumont, John P., 'Revolutionizing Runner Design In Hot and Cold Runner Mold,' ANTEC 2001, pp.3680-3687, 2001
  7. Song, J. Y., Park, T. W., Je, D. G., Jeong, Y. D., 'Injection Mold of Through Plate for Recycling,' J of KSPE, Vol. 20, No. 6, 200
  8. Isayev, A. I., 'Injection and compression Molding Fundamentals,' MARCEL DEKKER, INC, pp. 80-85, 1987
  9. VMTECH INC., CAPA, 'Injection molding analysis system,' 2003