Abstract
The existed mean that measured joint can usually be divided by the method that used bore-hole and phologrammetry. But, these measuring mean are many limitations, for example, spacial restriction, insufficient of gain data and observational error. In result, existing methods cannot obtain objective results and accurate reslts about joints. These faults must be overcame. So, this paper present joint investigation method with accuracy and efficiency. It is the three dimension laser scanner. In this paper conduct a study of accuracy and application of joint measurement using the three dimension laser scanner on rock slope. And an joints in object of study slope is measured by clinometer and the three dimension laser scanner, results by them is compared and analyzed. As a result of comparison, joint distribution is much the same. But method using the three dimension laser scanner could obtain many joint data. And it has objectification of datd, effect of ecnomy of time, a effect of economy in expenditure than method by clinometer. Also, the three dimension laser scanner could measure area that couldn't approach research, therefore it is very efficient method at research of joints.
기존 절리측정 방법은 크게 시추공을 이용한 측정방법과 수치사진측량을 이용한 측정방법으로 나눌 수 있다. 그러나 이러한 측정방법은 공간적 제약과 국한된 구간에서의 자료의 획득, 측정시의 오차로 전반적인 절리 자료의 획득에는 한계를 가질 수 밖에 없었으며, 객관적이고 정확한 결과를 얻기엔 무리가 있었다. 이러한 기존 절리측정 방법의 난점을 극복하고 정확도 및 효율성을 극대화 할 수 있는 방안으로 3차원 레이져 스캐너를 이용한 측정방법을 제시하고자 한다. 본 연구에서는 암반사면을 대상으로 3차원 레이저 스캐너를 이용한 절리측정의 정확성 및 활용 가능성을 연구하였다. 이를 위하여 레이저 스캐너와 클리노미터를 이용하여 대상사면의 절리를 측정하였으며, 이를 비교분석하였다. 레이저 스캐너와 클리노미터로 측정한 절리 분포 및 절리군의 방향성을 비교한 결과, 절리의 분포는 거의 동일하게 투영되었다. 3차원 스캐너를 이용한 결과에서는 다수 절리의 획득으로 클리노미터로 측정한 부분보다 더 많은 절리 데이터를 얻을 수 있었다. 따라서 암반사면조사 자료의 객관화, 조사기간의 단축, 조사 경비 절감 등의 효과가 있다. 또한 암반사면의 근접조사가 어려운 경우에도 조사가 가능하고 조사자의 안정성도 확보할 수 있어 절리측정에 매우 효과적인 방법임을 알 수 있었다.