DOI QR코드

DOI QR Code

Study on the Characteristics of Thrust and Torque for Partially Submerged Propeller

부분 침수 프로펠러의 bollard pull 추력 및 토오크 특성 연구

  • Received : 2011.10.07
  • Accepted : 2011.11.11
  • Published : 2011.11.25

Abstract

Shipbuilders carry out the operation test to check the conditions of the main propulsion system and auxiliaries for moored vessel in the quoy before the sea trial. The estimation of the thrust and torque for the partially submerged propeller should be prepared to ensure the safety of mooring line and the ship. In this paper, the variations of the thrust and torque according to the shaft submergence and the propeller rotating speed in bollard pull condition are investigated with the model test and the numerical analysis. Based on these resaearch, the empirical formula representing the physical phenomena of the partially submerged propeller is derived and validated through comparison to measurement results of full-scale propellers under the quoy operation test.

도크 내 공정을 마치고 진수된 선박은 안벽에 계류된 상태로 주기관 등의 시험 검사를 수행하게 된다. 주기관 시험을 수행할 경우 선박은 안벽에 고정된 상태에서 수면 위로 날개가 노출된 프로펠러를 회전시켜야 하므로, 이때 발생하는 추력과 토오크를 예상하여 안전상 문제가 없도록 시험 조건 선정 및 설치를 수행하여야 한다. 날개가 수면위로 노출된 프로펠러는 회전수 및 축 잠김 깊이에 따라 수면 노출 및 공기 유입 등의 영향으로 추력 및 토오크 감소율이 변화하게 된다. 본 논문에서는 당사 실적 선박 프로펠러에 대해 모형 시험과 수치 해석을 통하여 회전수 및 축 잠김 깊이에 따른 추력 및 토오크 변화 특성을 파악하고 이를 바탕으로 부분 침수 프로펠러의 bollard pull 조건에 대한 추정식을 도출하였다. 도출된 추정식을 실선 계측 결과와 비교하여 정도 높은 추정 결과를 제공하고 있는 것을 확인하였다.

Keywords

References

  1. Califano, A. and Steen, S., 2009, "Analysis of Different Propeller Ventilation Mechanism by means of RANS Simulations", 1st International Symposium on Marine Propulsors (SMP'09), Trondheim, Norway, June 2009.
  2. Chung, K.N. Won, J.C. Seo, H.W. and Choi, G.I., 1999, "A Study of Propeller Thrust in Dock Trials", Journal of the Society of Naval Architects of Korea, 36(1), pp.53-60.
  3. Fleischer, K.P., 1973, "Untersuchungen ber das Zusammenwirken von Schiff und Propeller bei tilgetauchten Propellern", Publication 35/75 of Forschungszentrum des Deutchen Schifbaus, Hamburg, Germany.
  4. Ha, M.K. Song, I.H. Kim, D.J. Wee, K.S. and Kim, S.W., 1997, "A Study on the Propeller Thrust for a Moored Ship", Journal of the Society of Naval Architects of Korea, 34(1), pp.50-59.
  5. Koushan, K., 2004, "Environmental and Interaction Effects on Propulsion Systems Used in Dynamic Positioning, an Overview", 9th Internaitonal Symposium on Practical Design of Ships and Other Floating Structures, Luebeck-Travemuende, Germany.
  6. Koushan, K., 2007, "Dynamics of Propeller Blade and Duct Loadings on Ventilated Thrusters in Dynamic Positioning Mode", Dynamic Positioning Conference, Houston, TX, United States., 9-10 October 2007.
  7. Kozlowska, A.M. Steen, S. and Koushan, K., 2009, "Classification of Different Type of Propeller Ventilation and Ventilation Inception Mechanism", 1st International Symposium on Marine Propulsors (SMP'09), Trondheim, Norway, June 2009.
  8. Minsaas, K. Wermter, R. and Hansen, A.G., 1975, "Scale Effects on Propulsion Factors", 14th International Towing Tank Conferences, Proceedings Volume3.
  9. Minsaas, K., Faltinsen O. and Person, B., 1983, "On the Importance of Added Resistance, Propeller Immersion and Propeller Ventilation for Large Ships in a Seaway", 2nd International Symposiumon Practical Design in Shipbuilding(PRADS), Tokyo and Seoul, pp.149-159.
  10. Shiba, H., 1953, "Air Drawing of Marine Propellers", Transportation Technical Research Institute, Report no. 9 Japan Aug. 1953.
  11. Wagner, H., 1925, "Uber die Entstehung des dynamischen Auftriebes vom Tragflugeln", Z.f.a.MM, Vol.5.Heft 1. Feb. 1925, pp.17-35.
  12. 25th International Towing Tank Conference 2008 (ITTC '08). ITTC-Recommended Procedures and Guidelines, 7.5-02-03-02.1.