DOI QR코드

DOI QR Code

Experimental Study on Capacity Variation of Paving Materials with TiO2 in Wet Condition

광촉매 이산화티타늄(TiO2)을 혼합한 도로 포장재의 습윤 조건에서의 성능 변화에 관한 실험적 연구

  • Seo, Dawa (Dept. of Civil and Environmental Engrg., Yonsei Univ.) ;
  • Yun, Tae Sup (Dept. of Civil and Environmental Engrg., Yonsei Univ.)
  • 서다와 (연세대학교 토목환경공학과) ;
  • 윤태섭 (연세대학교 토목환경공학과)
  • Received : 2016.03.31
  • Accepted : 2016.05.23
  • Published : 2016.05.31

Abstract

This study aims to present the practical Nitrogen monoxide (NO) removal capacity of cement mortar with Titanium dioxide ($TiO_2$) which is one of the paving materials by considering the environment of pavement in urban areas. NO removal capacity test under designated conditions of humidity of inflow gas and the test with variation of the degree of saturation of specimen were conducted. In the test for humidity, dry specimen is subject to the test and NO removal ratio was observed. Humidity-NO removal ratio curve is a log normal distribution in shape, and the maximum NO removal ratio appears at specific humidity. NO removal capacity test relying on the degree of saturation was carried out with wet specimen to reflect the unsaturated pavement by rainfall and domestic sewage. Wet specimen presents less NO removal capacity than dry specimen and the recovering evolution of NO removal capacity follows evaporation. Moreover, $TiO_2$ under the specific depth of specimen hardly contributes to NO removal capacity.

본 연구는 도심지의 도로 환경을 고려하여, 기능성 포장 재료 중 하나인 이산화티타늄($TiO_2$)을 포함한 시멘트 모르타르의 실질적인 일산화질소(NO) 제거 성능을 평가하고자 하였다. 실험은 크게 두 가지로, 유입되는 기체의 습도에 따른 NO 제거율 변화 실험과 시편의 포화도에 따른 NO 제거율 변화 실험으로 구성되었다. 습도 변화 실험에서는 건조 상태의 시편을 대상으로 유입 기체의 습도를 변화시키며 NO 제거율을 관찰하였다. 습도-NO 제거율 곡선은 로그 정규 분포 형상으로, 특정 습도에서 최대 NO 제거율이 나타났다. 포화도 변화 실험은 강우 및 생활 하수로 인하여 불포화 상태인 도로를 반영하고자 습윤 상태인 시편을 대상으로 하였다. 습윤 상태의 시편은 건조 상태보다 낮은 NO 제거 성능을 보였으며 증발이 진행되면서 $TiO_2$가 노출되어 NO 제거 성능이 증가하였다. 그리고 시편의 특정 깊이 아래에 존재하는 $TiO_2$는 NO 제거 성능에 크게 기여하지 않는 것으로 나타났다.

Keywords

References

  1. Ballari, M. M., Hunger, M., Husken, G., and Brouwers, H. J. H. (2010), "NOx Photocatalytic Degradation Employing Concrete Pavement Containing Titanium Dioxide", Applied Catalysis B: Environmental, Vol.95, No.3, pp.245-254. https://doi.org/10.1016/j.apcatb.2010.01.002
  2. Beeldens, A. (2006), An Environmental Friendly Solution for Air Purification and Self-cleaning Effect: the Application of $TiO_2$ as Photocatalyst in Concrete. Proceedings of Transport Research Arena Europe-TRA, Goteborg, Sweden.
  3. Chen, J. and Poon, C. S. (2009), "Photocatalytic Construction and Building Materials: from Fundamentals to Applications", Building and Environment, Vol.44, No.9, pp.1899-1906. https://doi.org/10.1016/j.buildenv.2009.01.002
  4. Choi, Y. J., Park, J., Lee, S., Heo, N., and Kim, W. (2002), "A Fundamental Study on the Properties of NOx Removal on Cement Mortar With $TiO_2$ Powder as Photocatalyst", Architectural Institute of Korea, Vol.18, No.8, pp.43-50 (in Korean).
  5. Dylla, H., Hassan, M., Mohammad, L., Rupnow, T., and Wright, E. (2010a), "Evaluation of Environmental Effectiveness of Titanium Dioxide Photocatalyst Coating for Concrete Pavement", Transportation Research Record: Journal of the Transportation Research Board, No.2164, pp.46-51.
  6. Dylla, H., Hassan, M. M., Schmitt, M., Rupnow, T., and Mohammad, L. N. (2010b), "Laboratory Investigation of the Effect of Mixed Nitrogen Dioxide and Nitrogen Oxide Gases on Titanium Dioxide Photocatalytic Efficiency in Concrete Pavements", Journal of Materials in Civil Engineering, Vol.23, No.7, pp.1087-1093. https://doi.org/10.1061/(ASCE)MT.1943-5533.0000248
  7. Environmental Protection Agency (EPA). (2010), Federal Register, Primary National Ambient Air Qulity Standards for Nitrogen Dioxide; Final Rule, Vol.75, No.26, United States.
  8. Husken, G., Hunger, M., and Brouwers, H. J. H. (2009), "Experimental Study of Photocatalytic Concrete Products for Air Purification", Building and environment, Vol.44, No.12, pp.2463-2474. https://doi.org/10.1016/j.buildenv.2009.04.010
  9. ISO (2007), Fine Ceramics (Advanced Ceramics, Advanced Technical Ceramics) - Test Method for Air-Purification Performance of Semiconducting Photocatalytic Materials, Part 1: Removal of Nitric Oxide.
  10. Jung, B., Kim, H., Park, J., Choi, Y., and Kim, W. (2001), "A Study on NOx Removal Capacity According to Admixture Replacement Ratio of Photocatalystic Interlocking Block", Architectural Institute of Korea, Vol.21, No.2, pp.403-406 (in Korean).
  11. Kim, J. J., Smorodinsky, S., Lipsett, M., Singer, B. C., Hodgson, A. T., and Ostro, B. (2004), "Traffic-Related Air Pollution near Busy Roads: The East Bay Children's Respiratory Health Study", American Journal of Respiratory and Critical Care Medicine, Vol.170, No.5, pp.520-536. https://doi.org/10.1164/rccm.200403-281OC
  12. Kim, Y. (2001), The Substance of the Photocatalysis. Daeyoung (In Korean).
  13. Lee, B. Y. (2012), Effect of Titanium Dioxide Nanoparticles on Early Age and Long Term Properties of Cementitious Materials, Ph.D. Dissertation, Georgia Institute of Technology, Atlanta, United States.
  14. Lehmann, P. and Or, D. (2009), "Evaporation and Capillary Coupling across Vertical Textural Contrasts in Porous Media", Physical Review E, Vol.80, No.4, pp.046318. https://doi.org/10.1103/PhysRevE.80.046318
  15. Lucas, S. S., Ferreira, V. M., and de Aguiar, J. B. (2013), "Incorporation of Titanium Dioxide Nanoparticles in Mortars-Influence of Microstructure in the Hardened State Properties and Photocatalytic Activity", Cement and Concrete Research, Vol.43, pp.112-120. https://doi.org/10.1016/j.cemconres.2012.09.007
  16. Poon, C. S. and Cheung, E. (2007), "NO Removal Efficiency of Photocatalytic Paving Blocks Prepared with Recycled Materials", Construction and Building Materials, Vol.21, No.8, pp.1746-1753. https://doi.org/10.1016/j.conbuildmat.2006.05.018
  17. Tao, Z., Hewings, G., and Kieran, D. (2010), "An Economic Analysis of Midwestern US Criteria Pollutant Emissions Trends from 1970 to 2000", Ecological Economics, Vol.69, No.8, pp.1666-1674. https://doi.org/10.1016/j.ecolecon.2010.03.016
  18. Yiotis, A. G., Tsimpanogiannis, I. N., Stubos, A. K., and Yortsos, Y. C. (2006), "Pore-network Study of the Characteristic Periods in the Drying of Porous Materials", Journal of Colloid and Interface Science, Vol.297, No.2, pp.738-748. https://doi.org/10.1016/j.jcis.2005.11.043