Journal of the Korea Concrete Institute (콘크리트학회논문집)

Korea Concrete Institute (한국콘크리트학회)
권호 표지
DOI QR코드

DOI QR Code

Simplified Moment-Curvature Relationship Model of Reinforced Concrete Columns Considering Confinement Effect

구속효과를 고려한 철근 콘크리트 기둥의 모멘트-곡률 관계 단순모델

  • Kwak, Min-Kyoung (Dept. of Architectural Engineering, Kyonggi University Graduate School) ;
  • Yang, Keun-Hyeok (Dept. of Plant.Architectural Engineering, Kyonggi University)
  • 곽민경 (경기대학교 건축공학과) ;
  • 양근혁 (경기대학교 플랜트.건축공학과)
  • Received : 2015.07.29
  • Accepted : 2016.03.25
  • Published : 2016.06.30
Download PDF
⟨ Previous Next ⟩

Abstract

The present study simplified the moment-curvature relationship to straightforwardly determine the flexural behavior of reinforced concrete (RC) columns. For the idealized column section, moments and neutral axis depths at different stages(first flexural crack, yielding of tensile reinforcing bar, maximum strength, and 80% of the maximum strength at the descending branch) were derived on the basis of the equilibrium condition of forces and compatibility condition. Concrete strains at the extreme compression fiber beyond the maximum strength were determined using the stress-strain relationship of confined concrete, proposed by Kim et al. The lateral load-displacement curves converted from the simplified moment-curvature relationship of columns are well consistent with test results obtained from column specimens under various parameters. The moments and the corresponding neutral axis depth at different stages were formulated as a function of longitudinal reinforcement and transverse reinforcement indices and/or applied axial load index. Overall, curvature ductility of columns was significantly affected by the axial load level as well as concrete compressive strength and the amount of longitudinal and transverse reinforcing bars.

이 연구에서는 철근콘크리트(reinforced concrete, RC) 기둥의 휨 거동을 비교적 간단한 방법으로 평가하기 위해서 모멘트-곡률 관계를 단순화하였다. RC 기둥에서 주철근 배근을 이상화하고 힘의 평형조건 및 변형률 적합조건에 기반하여 초기 휨 균열 발생, 인장철근 항복 도달, 최대 내력 및 최대 내력 도달 후 최대 내력의 80% 시점에서의 내력과 중립축 깊이를 산정하였다. 기둥의 최대 내력 이후의 콘크리트 압축연단 변형률은 Kim et al의 구속된 콘크리트 응력-변형률 관계를 이용하여 산정하였다. 단순화된 모멘트-곡률 관계로부터 환산된 기둥의 횡하중-횡변위 관계는 다양한 변수하에서 수행한 기둥 실험결과와 잘 일치하였다. 고려된 각 단계에서의 모멘트와 중립축 깊이는 주철근 지수, 횡보강근 체적지수 및 축력 지수의 함수로 모델링하였다. 결국, 기둥의 곡률 연성은 콘크리트 압축강도 및 주철근과 횡보강근의 양과 함께 작용 축하중비에 중요한 영향을 받았다.

Keywords

References

  1. Seo, S.Y., and Ham, J.H., "Experimental Study on the Confinement Effect of Headed Cross Tie in RC Column Subjected to Cycling Horizontal Load", Korea Institute for Structural Maintenance and Inspection, Vol.16 No.5, 2012, pp.1-10.
  2. Kim, J.K., Han, B.S., and Shin, S.W., "Ductility Capacity of Ultra-High Strength R/C Tied Columns Considering the Axial Load Ratio and Configuration of Transverse Reinforcement", Architectural Institute of Korea, Vol.25, No.1, 2009, pp. 3-11.
  3. ACI Committee 318, Building Code Requirements for Structural Concrete (ACI 318M-11) and Commentary, American Concrete Institute, Farmington Hills, Michigan, USA, 2011, p.503.
  4. Lee, Y.H., Chung, B.H., and Chung, H.S., "A Study on Confinement Effectiveness of Lateral Ties in RC Columns under Axial Loads", Architectural Institute of Korea, Vol.16, No.12, 2000, pp.3-11.
  5. Watson, S., and Park, R., "Simulated Seismic Load Tests on Reinforced Concrete Columns", Journal of Structural Engineering, ASCE, Vol.120 No.6, 1994, pp.1825-1849. https://doi.org/10.1061/(ASCE)0733-9445(1994)120:6(1825)
  6. Razvi, S., and Saatcioglu, M., "Confinement Model for High-Strength Concrete", Journal of Structural Engineering, ASCE, Vol.125, No.3, 1999, pp.281-289. https://doi.org/10.1061/(ASCE)0733-9445(1999)125:3(281)
  7. Park, S.Y., and Lee, Y.H., "A Clip Confinement Effect on the Behavior of Concrete Column subjected to High Axial and Reversed Cyclic Lateral Loads", Architectural Institute of Korea, Vol.24, No.10, 2008, pp.19-28.
  8. Sim, J.I., Yang, K.H., and Byun, H.Y., "Flexural Capacity and Ductility of Reinforced Concrete Columns Strengthened with Unbonded Wire Rope Units", Journal of the Korea Concrete Institute, Vol.21 No.2, 2009, pp.209-216.
  9. Razvi, S., and Saatcioglu, M., "Confinement Model for High-Strength Concrete", Journal of Structural Engineering, ASCE, Vol.125, No.3, 1999, pp.281-289. https://doi.org/10.1061/(ASCE)0733-9445(1999)125:3(281)
  10. Kang, S.M., and Park, H.G., "Moment-Curvature Relationship of Structural Walls with Confined Boundary Element", Journal of the Korea Concrete Institute, Vol.15, No.2, 2003, pp.281-288.
  11. Kwak, M.K., "Flexural Performance of Reinforced Concrete Columns with the Supplementary V-ties subjected to the Constant Axial Loads and Reversed Lateral Loads", MSc Thesis, Graduate School, Kyonggi University, 2016, p.142.
  12. Yang, K.H., Mun, J.H., Cho, M.S., and Kang, T.H.K., "A Stress-Strain Model for Various Unconfined Concrete in Compression", ACI Structural Journal, Vol.111, No.4, 2014, pp.819-826.
  13. Kim, W.W., Mun, J.H., and Yang, K.H., "Simplified Model for the Stress-Strain Relationship of Confined Concrete", Architectural Institute of Korea, Vol.16, No.5, 2012, pp. 1-10.
  14. Wallace, J.W., "Seismic Design of RC Structural Walls. Part I: New Code Format", Journal of Structural Engineering, ASCE, Vol.12, No.1, 1995, pp.88-101.
  15. Paulay, T., and Priestley, M.J.N., Seismic Design of Reinforced Concrete and Masonry Buildings, Wiley Interscience Publication, New Jersey, USA, 1992, p.768.
  16. Mun, J.H., and Yang, K.H., "Generalized Lateral Load-Displacement Relationship of Reinforced Concrete Shear Walls", Journal of the Korea Concrete Institute, Vol.26, No.2, 2014, pp.159-169. https://doi.org/10.4334/JKCI.2014.26.2.159
  17. Park, R., Priestley, M.H.N., and Gill, W.D., "Ductility of Square-Confined Concrete Columns", Journal of Structural Division, ASCE, Vol.108 No.ST4, 1982, pp.929-950.