Journal of the Korean Recycled Construction Resources Institute (한국건설순환자원학회논문집)

Korean Recycled Construction Resources Institute (한국건설순환자원학회)
권호 표지
DOI QR코드

DOI QR Code

Study on ECC Tensile Behavior due to Constrained Drying Shrinkage

구속된 건조수축에 따른 ECC의 인장거동에 관한 연구

  • 이도근 (충남대학교 토목공학과) ;
  • 이경찬 (한국철도기술연구원 첨단궤도토목본부 철도구조연구팀) ;
  • 이치동 (디엠엔지니어링) ;
  • 신경준 (충남대학교 토목공학과)
  • Received : 2019.10.23
  • Accepted : 2019.11.12
  • Published : 2019.12.30
Download PDF
⟨ Previous Next ⟩

Abstract

Drying shrinkage in the hardened cement is known to change in volume by decreasing the moisture content in the hardened body, and it is known that the higher the W / C and the higher the content of the paste, the larger the drying shrinkage. In the case of ECC, more drying shrinkage occurs compared to concrete, since it does not contain coarse aggregate. Since ECC is an important material for tensile performance, the effect of restrained tensile stress on mechanical tensile behavior should be considered. The purpose of this study is to analyze the effect of stress caused by restraint on the tensile behavior of ECC. The mechanical properties of the specimens were tested by uniaxial tension tests with different restraints. As a result, the difference of tensile behavior according to restraint stress was observed and the cause was analyzed.

시멘트 경화체에서 건조수축은 경화체내의 수분량이 감소하므로써 체적이 변화하게 되며, W/C가 높고 페이스트의 함유량이 많을수록 건조수축이 커진다고 알려져 있다. ECC의 경우, 굵은 골재를 포함하지 않기 때문에, 콘크리트에 비해서 더 많은 건조수축이 발생하게 된다. 만약, 양생중인 ECC에 구속이 작용할 경우, 일반 콘크리트 보다 큰 인장 응력이 발생하게 되며, ECC는 인장성능이 중요한 재료이므로 이러한 구속인장응력이 역학적 인장거동에 주는 영향을 고려해야 한다. 본 연구에서는 구속에 의해 발생한 응력이 ECC의 인장거동에 미치는 영향을 분석하고자 하였고, 구속여부를 달리하여 양생한 시험체에 직접인장 시험을 수행하여 역학적인 특성 변화를 관찰하였다. 그 결과, 구속응력에 따른 인장거동의 차이를 관찰하였고, 그 원인을 분석하였다.

Keywords

References

  1. Abbasnia, R., Godossi, P., Ahmadi, J. (2005). Prediction of restrained shrinkage based on restraint factors in patching repair mortar, Cement and Concrete Research, 35(10), 1909-1913. https://doi.org/10.1016/j.cemconres.2004.11.020
  2. ACI Committee 209R-92. Prediction of Creep, Shrinkage, and Temperature Effects in Concrete Structures, ACI Practice Manual.
  3. Arundhathy, S., Vasugi, V. (2016). Engineered cementitious composites for sustainable construction, Key Engineering Materials, 692, 17-26. https://doi.org/10.4028/www.scientific.net/KEM.692.17
  4. Cha, S.W., Oh, B.H., Lee, H.J. (2002). Evaluation of thermal and shrinkage stresses in hardening concrete considering early-age creep effect, Journal of the Korea Concrete Institute, 14(3), 382-289 [in Korean]. https://doi.org/10.4334/JKCI.2002.14.3.382
  5. Deshpande, U.L., Murnal, P.B. (2016). Ductile Concrete Using Engineered Cementitious Composites, International Journal of Engineering Research, 5013(5), 756-760.
  6. Hajj, E.Y., Sanders, D.H., Weitzel, N.D. (2016). Development of Specifications for Engineered Cementitious Composites for Use in Bridge Deck Overlays, NDOT Project 13-39, Nevada Department of Transportation, February 2016, FINAL REPORT.
  7. Han, C.G., Han, M.C., Song, S.H., Yoon, S. (2009). Drying shrinkage of concrete combining expansive additives and shrinkage reducing agent, Journal of the Korea Concrete Institute, 93, 87-94 [in Korean].
  8. Han, M.C. (2006). Prediction of setting time of super retarding concrete incorporating blast furnace slag, Architectural Research(structural part), 22(12), 87-95 [in Korean].
  9. Kim, J.H., Yoon, H.D., Jun, E. (2006). Material design, characteristics and application of engineered cementitious composites, Magazine of the Korea Concrete Institute, 18(1), 28-35 [in Korean].
  10. Kim, Y.Y. (2007). Design and constructibility of an engineered cementitious composite produced with cement-based mortar matrix and synthetic fibers, Korean Society for Composite Materials, 20(2), 21-26 [in Korean].
  11. Kim, Y.Y., Li, V.C. (2003). Performance of Engineered Cementitious Composites (ECC) Link Slabs for Jointless Bridge Deck System, Journal of the Korean Society of Civil Engineers A, 23(6A), 1143-1154 [in Korean].
  12. Krouma, A., Syed, Z.I. (2016). A review on the use of engineered cementitious composite in bridges, Materials Science Forum, 860, 125-134. https://doi.org/10.4028/www.scientific.net/MSF.860.125
  13. Kwon, S.H., Kim, J.K. (2016). Understanding of drying shrinkage and autogeneous shrinkage in concrete, special articles, Magazine of the Korea Concrete Institute, 28(6), 22-26 [in Korean].
  14. Lee, H.B. (2014). Evaluation of residual stress using IITC of experimental stress analysis on concrete structure, KSCE Journal of Civil Engineering, 34(2), 415-424 [in Korean].
  15. Li, V.C. (2011). Engineered Cementitious Composites (ECC)-Material, Structural, and Durability Performance.
  16. Li, V.C., Fischer, G., Kim, Y.Y, Lepech, M., Qian, S., Weimann, M., Wang, S. (2003). Durable Link Slabs for Jointless Bridge Decks Base on Strain-Hardening Cementitious Composite, MODT Project, Michigan Department of Transportation, November 2003, FINAL REPORT.
  17. Mehta, P.K., Monteiro, P.J.M. (2014). Concrete, Microstructure Properties and Materials, Third edition, McGraw-Hill, NewYork.
  18. Mindess, S., Young, J.F., Darwin, D. (2003). Concrete, Second edition, Prentice Hall.
  19. Oluokun, F.A. (1991). Prediction of concrete tensile strength from its compressive strength evaluation relations for normal weight concrete, ACI Materials Journal, 88(3), 302-309.
  20. Park, S,G, (2017). Prediction and reduction technology of concrete shrinkage, Technology Lecture, Magazine of the Korea Concrete Institute, 29(6), 57-64 [in Korean].
  21. Ryu, D.Y., Park, J.J., Kim, S.W., Yoon, Y.S. (2011). Characteristics of early-age restrained shrinkage and tensile creep of ultra-high performance cementitious composites (UHPCC), Journal of the Korea Concrete Institute, 23(5), 581-590 [in Korean]. https://doi.org/10.4334/JKCI.2011.23.5.581
  22. Ryu, S.S. (2017). Effect of Pore Structures in Coarse Aggregate on the Shrinkage of Concrete, Ph.D Thesis, Joongbu University, Korea [in Korean].
  23. Shin, K.J., Lee, D,K,, Seo, D.W., Yoo, C.M., Lim, M.H., Lim, S.H. (2016). Setting estimation of cement paste using new-type embedded sensor, Journal of the Korean Recycled Construction Resources Institute, 4(4), 483-488 [in Korean]. https://doi.org/10.14190/JRCR.2016.4.4.483
  24. Son, S.W., Ahn, T.H., Jeon, Y.S., Ahn, S.K., Jung, S.H. (2015). Bleeding and setting time of concrete using modified fly ash, Korea Concrete Institute Spring Convention, 27(1), 577-578 [in Korean].
  25. Yang, S.C., Ahn, N.S., Choi, D.W., Kang, S.M. (2004). Drying shrinkage of concretes according to different volume-surface ratios and aggregate types, International Journal of Highway Engineering, 6(4), 109-121 [in Korean].
  26. Yoshitake, I., Rajabipour, F., Mimura, Y., Scanlon, A. (2012). A Prediction Method of Tensile Young's Modulus of Concrete at Early Age, Advances in Civil Engineering, Hindawi.
  27. Yu, K., Wang, Y., Yu, J., Xu, S. (2017). A strain-hardening cementitious composites with the tensile capacity up to 8%, Construction and Building Materials, 137, 410-419. https://doi.org/10.1016/j.conbuildmat.2017.01.060
  28. Yu, K., Wang, Y., Yu, J., Xu, S. (2017). Experimental study on crack bridging in engineered cementitious composites under fatigue tensile loading, Construction and Building Materials, 154, 167-175. https://doi.org/10.1016/j.conbuildmat.2017.07.193