An Experimental Analysis of Effective Thermal Conductivity of Porous Materials Using Structural Models

구조모델을 이용한 다공성 매질의 유효열전도도 분석

  • Cha, Jang-Hwan (Department of Geoenvironmental Sciences, Kongju National University) ;
  • Koo, Min-Ho (Department of Geoenvironmental Sciences, Kongju National University) ;
  • Keehm, Young-Seuk (Department of Geoenvironmental Sciences, Kongju National University)
  • 차장환 (공주대학교 지질환경과학과) ;
  • 구민호 (공주대학교 지질환경과학과) ;
  • 김영석 (공주대학교 지질환경과학과)
  • Received : 2010.10.06
  • Accepted : 2010.10.13
  • Published : 2010.12.31

Abstract

The effective thermal conductivity of porous materials is usually determined by porosity, water content, and the conductivity of the matrix. In addition, it is also affected by the internal structure of the materials such as the size, arrangement, and connectivity of the matrix-forming grains. Based on the structural models for multi-phase materials, thermal conductivities of soils and sands measured with varying the water content were analyzed. Thermal conductivities of dry samples were likely to fall in the region between the Maxwell-Eucken model with air as the continuous phase and the matrix as the dispersed phase ($ME_{air}$) and the co-continuous (CC) model. However, water-saturated samples moved down to the region between the $ME_{wat}$ model and the series model. The predictive inconsistency of the structural models for dry and water-saturated samples may be caused by the increase of porosity for water-saturated samples, which leads to decrease of connectivity among the grains of matrix. In cases of variably saturated samples with a uniform grain size, the thermal conductivity showed progressive changes of the structural models from the $ME_{air}$ model to the $ME_{wat}$ model depending on the water content. Especially, an abrupt increase found in 0-20% of the water content, showing transition from the $ME_{air}$ model to the CC model, can be attributed to change of water from the dispersed to continuous phase. On the contrary, the undisturbed soil samples with various sizes of grains showed a gradual increase of conductivity during the transition from the $ME_{air}$ model to the CC model.

Keywords

References

  1. 차장환, 안선준, 구민호, 김형찬, 송윤호, 서명석, 2008, 토양의 공극률 및 함수비가 열전도도에 미치는 영향, 지하수토양환경, 13(3), 27-36.
  2. Beardsmore, G.R. and Cull, J.P., 2001, Crustal heat flow : A guide to measurement and modelling, Cambridge Univ. Press, USA, p. 324.
  3. Carson, J.K., Lovatt, S.J., Tanner, D.J., and Cleland, A.C., 2003, An analysis of the influence of material structure on the effective thermal conductivity of theoretical porous materials using finite element simulations, Int. J. of Refrigeration, 26, 873-880. https://doi.org/10.1016/S0140-7007(03)00094-X
  4. Carson, J.K., Lovatt, S.J., Tanner, D.J., and Cleland, A.C., 2005, Thermal conductivity bounds for isotropic, porous materials, Int. J. of Heat and Mass Transfer, 48, 2150-2158. https://doi.org/10.1016/j.ijheatmasstransfer.2004.12.032
  5. Cote, J. and Konrad, J., 2009, Assessment of structure effects on the thermal conductivity of two-phase porous geomaterials, Int. J. of Heat and Mass Transfer, 52, 796-804. https://doi.org/10.1016/j.ijheatmasstransfer.2008.07.037
  6. Jessop, A.M., 2008, Models of thermal conductivity of crystalline rocks, Int. J. of Earth Sci, 97, 413-419. https://doi.org/10.1007/s00531-007-0214-y
  7. Kersten, M.S., 1949, Laboratory research for the determination of the thermal properties of soils, Research laboratory Investigations, Engineering Experiment Station, Technical Report 23, University of Minnesota, Minneapolis, Minn.
  8. Kohout, M., Collier, A.P., and Stepanek, F., 2004, Effective thermal conductivity of wet particle assemblies, Int. J. of Heat and Mass Transfer, 47, 5565-5574. https://doi.org/10.1016/j.ijheatmasstransfer.2004.07.031
  9. Lu, S., Ren, T., Gong, Y., and Horton, R., 2007, An Improved model for predicting soil thermal conductivity from water content at room temperature, Soil Sci. Soc. Am. J., 71, 8-14. https://doi.org/10.2136/sssaj2006.0041
  10. Singh, D.N. and Devid, K., 2000, Generalized relationships for estimating soil thermal resistivity, Exp. Thermal and Fluid Sci., 22, 133-143. https://doi.org/10.1016/S0894-1777(00)00020-0
  11. Vasseur, G., Brigaud, F., and Demongodin, L., 1995, Thermal conductivity estimation in sedimentary basins, Tectonophysics, 244, 167-174. https://doi.org/10.1016/0040-1951(94)00225-X
  12. Wang, J., Carson, J.K., North, M.F., and Cleland, D.J., 2006, A new approach to modelling the effective thermal conductivity of heterogeneous materials, Int. J. of Heat and Mass Transfer, 49, 3075-3083. https://doi.org/10.1016/j.ijheatmasstransfer.2006.02.007
  13. Wang, J., Carson, J.K., North, M.F., and Cleland, D.J., 2008, A new structural model of effective thermal conductivity for heterogeneous materials with co-continuous phases, Int. J. of Heat and Mass Transfer, 51, 2389-2397. https://doi.org/10.1016/j.ijheatmasstransfer.2007.08.028